Boat Suppliers Fast Epoxy Hardener 4:1 Ratio

Hardener speed sets working time and cure time, not final strength. West System 205 Fast gives 9 to 12 minutes of pot life (100 g at 72°F), cures down to 40°F and suits cool shops and small batches. 206 Slow gives 20 to 25 minutes for warm shops and bigger layups, and 209 Extra Slow about 40 to 50 minutes. Always mix at the ratio the system specifies.

The ratio is fixed by the resin and hardener chemistry, not by strength, so each system has its own ratio you must follow exactly. West System uses 5 parts resin to 1 part hardener, while our Boat Suppliers hardeners come in 2:1, 3:1, and 4:1 versions. A lower ratio like 2:1 means more hardener by volume and is easier to measure. Choose cure speed by hardener type, never by changing the ratio.

Follow the specific mix ratio provided by the manufacturer (commonly 2:1 or 1:1 by volume). Mix thoroughly in a clean container, scraping the sides and bottom, until the blend is uniform and streak-free.

Amine blush is a waxy film that forms on curing epoxy as it reacts with moisture and carbon dioxide in the air, most often in cool, humid conditions. Left on, it blocks adhesion of the next coat, paint, or gelcoat. Wash the cured surface with plain water and a Scotch-Brite pad, dry it, then sand. West System 207 hardener is formulated to resist blushing.

Yes, but cold slows the cure and thickens the resin. Below about 60°F most epoxies cure slowly and can stay tacky, and below freezing they may not cure at all. Warm the resin and hardener to room temperature before mixing, heat the work area, and choose a fast hardener for low temperatures. Never add solvent to thin cold epoxy, since that weakens the cured bond.