Foam Brush
SKU:FOAM-10
In stock
Couldn't load pickup availability
A foam brush for laying thin, even coats of epoxy, varnish, polyurethane, stain or resin, made to be used on the job and thrown away after. Pick the width that matches the work: 1, 2, 3 or 4 inches.
Matching the width to the job
Run the 1 inch on edges, trim, small parts and inside corners. The 2 inch covers rails, handholds and most brightwork. Go to 3 or 4 inches on panels, hatch lids and flat sections, where a wider head means fewer passes and fewer lap marks. The fine-celled, dense foam leaves a smooth film with few bubbles, which also makes it a good tool for tipping off a fresh coat of epoxy or varnish. Keep a wet edge as you go.
- Widths: 1 in, 2 in, 3 in or 4 in
- Head: fine-celled dense foam
- Handle: wood
- Coatings: epoxy, varnish, polyurethane, stain, resin
Specifications

What kind of brush works with polyester resin and epoxy?
Disposable natural-bristle chip brushes are the shop standard for resin and gelcoat. They are cheap enough to throw away after a batch, and the bristles hold up to the styrene in polyester. Foam brushes work for thin coats and small touch-ups but can break down in solvent-heavy resin. Buy chip brushes in bulk, since resin ruins them and they are not worth cleaning.