Sea Dog 3" Recessed Drink Holder 2" Deep

A flush recessed drink holder that drops into a 3 in hole in a console, gunwale liner or seat back. Injection molded with drain holes in the base, so rain and condensation run out the bottom instead of leaving a cup of water in the holder for the next three weeks.

• Cutout: requires a 3 in hole. Measure and drill with a hole saw, not by eye.
• Depth: 2 in, which suits cans and short bottles. Check your clearance behind the panel before you cut.
• Self draining through molded holes in the base.
• Two colors: black (588000) and white (588001).

Before the hole saw goes through, check what is behind the panel. A drink holder that drains straight onto a wiring harness or into a foam-filled cavity is worse than no drink holder at all, and a 3 in hole is not something you undo.