Cartoon nautical chart of the boat route from Any Loop starting point to Back to the start (full circumnavigation).

How long is the Great Loop?

Boat Suppliers
Boat Suppliers

07 June 2026

The Great Loop is a roughly 5,200 nautical mile circuit, or about 5,984 statute miles and 9,630 kilometers, that runs up the East Coast, through New York and the Great Lakes, down the inland rivers to the Gulf, and back across to Florida to close the loop. Most people run it as a one year clockwise circuit, chasing fair weather north in summer and south in winter. It is not one passage but hundreds of day runs strung together, so plan it leg by leg, not as a single distance.

Great Loop total distance

Measure Value
Total circuit (straight-line basis) about 5,200 nautical miles
Statute miles about 5,984 miles
Kilometers about 9,630 km
Typical on-the-water routing about 5,400 nautical miles

The headline number varies by the side trips and detours you add, so treat 5,000 to 5,500 nautical miles as the working range. The water is overwhelmingly protected inland, with a few open stretches, the Gulf crossing and parts of the Great Lakes, that demand a real weather window. Pace and seasonal timing matter far more than any one day of weather.

How long does it take, and how much fuel, by boat type

These figures are the raw running totals from the same engine that powers our boat fuel calculator, applied across the full 5,200 nautical mile circuit at a steady cruise. They are running hours and total burn, not calendar time: nobody runs the Loop non-stop. Most Loopers take a full year, averaging a few hours of travel on the days they move. Use the numbers to size a fuel budget, then plan your real days leg by leg in the calculator below.

Boat Cruise GPH MPG Running time Total fuel Fuel cost
24 ft center console (twin 150s) 28 mph 17.2 1.6 about 214 hr 3,679 gal $16,554
38 ft express cruiser (twin gas) 26 mph 43.0 0.6 about 230 hr 9,904 gal $44,569
50 ft trawler (single diesel) 10 mph 21.7 0.5 about 598 hr 12,966 gal $58,345

Fuel cost assumes $4.50 per gallon. A slow trawler burns the most total fuel because it spends the most hours under way, even though it sips the fewest gallons per hour. This is why most Loopers run a single diesel trawler for the range and the comfort, then watch the fuel budget closely. Do not just scale from the table: run your own hull and load.

Estimate the fuel for a typical Loop day

The calculator below is pre-loaded with a representative 50 nautical mile day leg, which is how you actually plan the Loop, one day at a time. Change the engine, horsepower, load, cruise speed, tank, and trip distance to match your boat and your planned run, and it recomputes the fuel, range, and time instantly.

Open the fuel calculator, pre-filled for this trip

Best season and timing for the Loop

Best approach: a one year clockwise circuit, running north in summer and south in winter to stay in the good weather.

The Great Loop is not a single passage but a roughly 5,000 nautical mile circuit. The water is overwhelmingly protected inland, with a few open stretches, the Gulf crossing and parts of the lakes, that demand a clean weather window. Pace and seasonal timing matter far more than any one day of weather, so plan around the seasons first and the daily forecast second.

The legs of the Loop

  • Atlantic Intracoastal Waterway: the East Coast leg from Florida up to the Hudson, mostly protected inside water.
  • Hudson River and Erie Canal: up the Hudson and west through the canal system, where air draft and lock schedules drive your days.
  • Great Lakes: across the lakes to Chicago, with a few open crossings that need a settled forecast.
  • Inland rivers: down the Illinois, Mississippi, Tennessee, and Tombigbee river system to the Gulf, where current and barge traffic set the pace.
  • Gulf of Mexico and Florida: across the Gulf and back up to close the loop, the one stretch that most demands a real weather window.

Gear to sort before you go

  • A fuel system you trust over thousands of miles: clean filters, a known tank gauge, and a real reserve plan, not a guess.
  • Ground tackle sized for the open anchorages you will use along the way.
  • A hull and gelcoat in good repair before a year on the water; fix the soft spots and chips at the dock, not on the river.

Getting the boat ready for a long season? See our fuel tanks and systems and marine gelcoats for the repair and maintenance supplies that keep a long run uneventful.

The Great Loop: frequently asked questions

How far is Back to the start (full circumnavigation) from Any Loop starting point?

Back to the start (full circumnavigation) is about 5200 nautical miles from Any Loop starting point, which is roughly 5984 statute miles or 9630 kilometers in a straight line. A typical on-the-water routing runs about 5400 nautical miles.

How long does it take to get from Any Loop starting point to Back to the start (full circumnavigation) by boat?

A 24 ft center console (twin 150s) cruising at about 28 mph covers the 5200 nautical mile run in roughly 213 hours 43 minutes. A slower trawler takes much longer, and a fast express cruiser a little less. Use the fuel calculator on this page to plug in your own boat.

How much fuel does the Any Loop starting point to Back to the start (full circumnavigation) trip use?

The 24 ft center console (twin 150s) burns about 3679 gallons on the 5200 nautical mile run at roughly 17.2 gallons per hour and 1.6 miles per gallon. Your number depends on horsepower, load, and cruise speed, so run your own boat through the calculator below.

Back to blog